AFD30-F02D,*日本SMC大流量型油霧器
Set the pressure within the rated pressure range.
The regulating pressure range is the range of pressure that is possible in setting.
The rated pressure range is the range of pressure that satisfies the specifications （accuracy, linearity, etc.） on the sensor.
Although it is possible to set a value outside the rated pressure range, the specifications will not be guaranteed even if the value stays within
the regulating pressure range.
注1 ）油箱壓力自動進料罐和管道壓力的壓力是自動送料潤滑油的壓力。
注2 ）條件：進氣壓力0.5兆帕， 5滴/分鐘，透平油1（無添加劑） ISO VG32 ，溫度20℃，針*開空氣消耗率zui低的操作流程。
注3）容量之間的水平：浮球開關裝備模型的情況下，容量計量水平之間的液位計上限
浮子開關檢知范圍的下限。
Working Principle/Auto Feed Lube
The oil that has been pumped from the tank
passes through felt q where it is filtered,
and is fed into the case through nozzle w.
When the volume of oil reaches a certain
level, float e ascends, valve t descends via
AFD30-F02D,*日本SMC大流量型油霧器
lever r, nozzle w closes, and the feeding of
oil stops, thus completing the oil feeding
process. When the oil inside the case is
consumed, float e descends, valve t ascends
via lever r, allowing oil to be fed
from nozzle w.
If the pressure is discharged, the oil could
flow back if the operating pressure differential
range （the differential between the
tank and line pressures） exceeds 0.6
MPa. Therefore, make sure to also discharge
the tank pressure.
Install the float vertically inside the bowl
so that it will not come into contact with
the siphon tube, preventing the oil from
dripping poorly.
Oil cannot be fed into Auto Feed Lube under
being pressurized. We recommend oil
is supplied from cam handle （plug for oil
supply） of an auto feed tank.